Advantech ADAM-5240
4-axis Stepping/Pulse-type Servo Motor Control Module
- High-speed 4-axis stepping/pulse-type servo motion control
- Hand wheel and jog function
- 2/3-axis linear interpolation function
- 2-axis circular interpolation function
- Continuous interpolation function
- Programmable T/S-curve acceleration/deceleration rate
- Up to 4 MPPS output for each axis
- Two pulse output types: CW/CCW or Pulse/Direction
- Up to 1 MHz encoder input for each axis
- Two encoder pulse input types: A/B phase or Up/Down
- Position management and software limit switch function
Advantech´s Industrial Automation Group introduces the ADAM-5240, a 4-axis Stepping/Pulse-type Servo Motor Control Module for use with ADAM-5550 Series PACs (Programmable Automation Controllers). ADAM-5240 is is fully integrated to fulfill general purpose motion applications. Equipped with high speed 4-axis motion control module that simplifies stepping and pulse-type servo motor control, ADAM-5240 provides advanced performance.
General
- Certifications
CE
Power Consumption
1.1 W (Max.)
Enclosure
ABS+PC
Connectors
100-pin SCSI-II female
Motion
- Number of Axis
4 Axis
External Power input
DC +12 ~ 24 Vdc
2/3-axis Linear Interpolation/ 2-axis Circular Interpolation
Range
±2, 147, 483, 646 for each axis
Speed
1PPS ~ 4MPPS
Continuous Interpolation
- Speed
1PPS ~ 2MPPS
Drive Output Pulses
- Range
1PPS ~ 4MPPS
Pulse Output Type
Pulse /Direction
(1-pulse, 1- direction type)
Up/Down (2-pulse type)
Speed Curve
T/S-curve Acceleration/
Deceleration
Input Pulse for Encoder Interface
- Encoder Pulse Input Type
Quadrature (A/B phase or Up/Down)
Counts per Encoder Cycle
X1, X2 ,X4 (A/B phase only)
Protection
1,000 Vdc isolation
Input Range
5 V ~ 30 V
External Deceleration/Instantaneous Stop Signal
- Input Signal
nIN1 ~ 3
Max Input Frequency
4 kHz
Protection
1,000 Vdc Photo coupler isolation
Input Pulse for Servo Motor Drives
- Input Signal
nALArm (servo alarm)
nINPOS (position command completed)
General Purpose Output Signal
- Ouput Signal
nOUT4 ~ 7
Emergency Stop
- Input Signal
EMG – one emergency stop input for ADAM-5240
Protection
1000 Vdc Photo coupler isolation and RC filtering
Note:
only for ADAM-5550 Series
Customers who viewed this item also viewed